Your cart is empty

Hobbyzone motor mount for a Turnigy G10

Price: $15.99
  • Model: A100080
  • Units in Stock: 19
  • Manufactured by: Custom RC Parts

Add to Cart:
Click image to enlarge

The Custom RC Parts designed motor mount for the Super Cub and Super Cub LP allows you to install a Turnigy G10 on your plane.

This mount has a compound angle machined into it which maintains the stock thrust angle of the motor. There are no shims or spacers necessary.

It is CNC machined out of 6061-T6 billet Aluminum.

All fasteners are included.


6061-T6 Aluminum.

19mm X 25mm slots for 3mm fasteners.

14mm clearance hole.

Designed for motors with an operating length "F" of 61mm.

Weight: 12g

E-flite Power 15
Turnigy G20

HobbyZone Super Cub
HobbyZone Super Cub LP

The prop adapter that ships with the G10 is 8mm. This may not fit all props.

The prop adapter shown in the images is off an E-flite Power 10. The prop adapter that shipped with the G10 does not fit APC props that would be installed on a Super Cub

1. Install the motor mount using the 4, M3-.5 X 6 fasteners. Screw the fasteners in until they contact the motor mount then back them out a quarter turn. Ensure that the collar on the motor is centered in the clearance hole in the motor mount. Now tighten the fasteners. Once the motor is secured to the mount, spin the motor to make sure that there are no interferences. It’s a good idea to use a little Loctite on the threads.

2. Install the motor and mount on the plane using the #4 X 1/2” and #4 X 5/8” fasteners. Looking at the front of your plane, the 1/2” long fasteners go in the left side (the thin side of the mount) and the 5/8” long fasteners go on the right (the thick side of the mount). I like how the fasteners have more engagement than the stock fasteners, but you can reuse the stock fasteners if you like.
CAUTION: You are installing fasteners into plastic. Do not over tighten the fasteners.

3. Route the wires through the firewall.

4. Install the cowl and check for interferences.

5. Install the prop adapter and prop and you are all set!

6. As with any change to your plane, before flying ensure that the center of gravity is correct!