Your cart is empty

P-47D Thunderbolt motor mount for the stock 15BL

Price: $15.99
  • Model: A100018
  • Units in Stock: 6
  • Manufactured by: Custom RC Parts

Add to Cart:
Click image to enlarge

The Custom RC Parts designed motor mount for the Parkzone P-47D Thunderbolt. This mount is a replacement for the stock plastic mount.

It is machined out of 6061-T6 billet Aluminum.

All fasteners are included.

6061-T6 Aluminum.

19mm X 30mm slots for 3mm fasteners.

14.0mm clearance hole.

Designed for motors with an operating length "F" of 67mm.

Weight: 21g

E-flite Power 25
Parkzone 15BL

Parkzone P-47D Thunderbolt
Parkzone T-28 Trojan
Parkzone Stinson Reliant SR-10
Parkzone F4U Corsair

1. Install the motor mount using the 4, M3-.5 X 8 fasteners. Screw the fasteners in until they contact the motor mount then back them out a quarter turn. Ensure that the collar on the motor is centered in the clearance hole in the motor mount. Now tighten the fasteners. Once the motor is secured to the mount, spin the motor to make sure that there are no interferences.CAUTION: You are installing fasteners into plastic. Do not over tighten the fasteners.2. Install the motor and mount on the plane using the #4 X 1/2” fasteners. I like how the fasteners have more engagement than the stock fasteners, but you can reuse the stock fasteners if you like. CAUTION: You are installing fasteners into plastic. Do not over tighten the fasteners.3. Route the wires through the firewall. 4. Install the cowl and check for interferences. 5. Install the prop adapter and prop and you are all set!6. As with any change to your plane, before flying ensure that the center of gravity is correct!