Your cart is empty

P-47D Thunderbolt Motor Mount for an Turnigy C3542

Price: $15.99
  • Model: A100101
  • Units in Stock: 27
  • Manufactured by: Custom RC Parts

Add to Cart:
Click image to enlarge

The Custom RC Parts designed motor mount for the ParkZone P-47D Thunderbolt.

This mount allows you to install a Turnigy C3542 on your plane.

It is machined out of 6061-T6 billet Aluminum.

All fasteners are included.

6061-T6 Aluminum.

16mm X 25mm slots for 3mm fasteners.

11.13mm clearance hole.

Designed for motors with an operating length "F" of 47mm.

Weight: 27g

Turnigy C3542-1000
Turnigy C3542-1100
Turnigy C3542-1250
Turnigy C3542-1450

Parkzone P-47D Thunderbolt
Parkzone T-28 Trojan
Parkzone Stinson Reliant SR-10
Parkzone F4U Corsair

The prop shaft clearance hole needs to be opened up to approximately 1.0".

A prop spacer is required to achieve the necessary clearance between the prop and the cowl.

The spacer is included.

1. Attach the motor to the motor mount using the 4, M3-.5 X 6 fasteners. Screw the fasteners in until they contact the motor mount then back them out a quarter turn. Ensure that the collar on the motor is centered in the clearance hole in the motor mount. Now tighten the fasteners. Once the motor is secured to the mount, spin the motor to make sure that there are no interferences. It’s a good idea to use a little Loctite on the threads.

2. Install the motor and mount on the plane using the #4 X 1/2” fasteners. I like how the fasteners have more engagement than the stock fasteners, but you can reuse the stock fasteners if you like.
CAUTION: You are installing fasteners into plastic. Do not over tighten the fasteners and don not use Loctite on these fasteners!

3. Route the wires through the firewall.

4. You have to open up the prop shaft clearance hole to 1.0”

5. Install the cowl and check for interferences.

6. Install the prop adapter and prop and you are all set!

7. As with any change to your plane, before flying ensure that the center of gravity is correct!