Your cart is empty

BF-109G Messerschmitt Motor Mount for an EFlite Power 15

Price: $24.99
  • Model: A100032
  • Units in Stock: 17
  • Manufactured by: Custom RC Parts

Add to Cart:
Click image to enlarge

The Custom RC Parts designed motor mount for the ParkZone BF-109G Messerschmitt allows you to install an E-flite Power 15 on your plane.

The mount and washer are machined out of 6061-T6 billet Aluminum. The custom prop shaft is machined out of 7075-T6 Aluminum. The mount and shaft are anodized black.

The motor shaft needs to be pressed through the motor. The custom prop shaft bolts on to the front of the magnet housing. The exact stock look is maintained. The mount fits 19mm X 19 to 25mm X 25mm motors using 3mm fasteners.

All fasteners are included.


Mount: 6061-T6 Aluminum.
Anodized black.

Prop Shaft: 7075-T6 Aluminum
Anodized black.

Prop Spacer: 6061-T6

19mm X 25mm slots for 3mm fasteners.

14.0mm clearance hole.

Designed for motors with an operating length "F" of 54mm.

Mount weight: 13g
Shaft weight: 9g
Spacer weight: 3g

E-flite Power 15

ParkZone BF-109G Messerschmitt

The shaft on the motor must be pressed through.

Click here for detailed instructions how to press the shaft through.

1. Before installing the motor you need to press the shaft through. Please see this tutorial on how to do that.

2. Install the motor on the motor mount using the 4, M3-.5 X 6 fasteners. Screw the fasteners in until they contact the motor mount then back them out a quarter turn. Ensure that the collar on the motor is centered in the clearance hole in the motor mount. Now tighten the fasteners. Once the motor is secured to the mount, spin the motor to make sure that there are no interferences. It’s a good idea to use a little Loctite on the threads.

3. Install the prop shaft on the motor using the 3, M2.5 X 10 fasteners.

4. Install the motor and mount on the plane using the #4 X 1/2” fasteners. I like how the fasteners have more engagement than the stock fasteners, but you can reuse the stock fasteners if you like.
CAUTION: You are installing fasteners into plastic. Do not over tighten the fasteners.

5. Route the wires through the firewall.

6. Install the cowl and check for interferences.

7. Install the spinner base, prop, prop spacer, prop nut and the spinner and you are all set!

8. As with any change to your plane, before flying ensure that the center of gravity is correct!