Your cart is empty

P-51D motor mount for a Turnigy D3536

Price: $15.99
  • Model: A100105
  • Units in Stock: 21
  • Manufactured by: Custom RC Parts

Add to Cart:
Click image to enlarge

The Custom RC Parts designed motor mount for the Parkzone P-51D Mustang.

This mount allows you to install a Turnigy D3536 on your plane.

It is machined out of 6061-T6 billet Aluminum.

All fasteners are included.

6061-T6 Aluminum.

19mm X 25mm slots for 3mm fasteners.

14.0mm clearance hole.

Designed for motors with an operating length "F" of 50mm.

Weight: 11g

Turnigy D3536

ParkZone P-51D Mustang BL
ParkZone F4F Wildcat

The stock spinner works well with the stock prop and Master Airscrew props.

APC props will not fit without modifying the spinner and/or the prop. The mount does not affect the fit of the prop.

The Great Planes p/n GPMQ4773 allows you to use APC props.

The Turnigy D3536 has an 8mm prop shaft. If you want to use the stock prop and spinner you will have to drill them so they fit the prop shaft. The same goes for the Great Planes spinner.

1. Attach the motor to the motor mount using the 4, M3-.5 X 6 fasteners. Screw the fasteners in until they contact the motor mount then back them out a quarter turn. Ensure that the collar on the motor is centered in the clearance hole in the motor mount. Now tighten the fasteners. Once the motor is secured to the mount, spin the motor to make sure that there are no interferences. It’s a good idea to use a little Loctite on the threads.

2. Install the motor and mount on the plane using the #4 X 1/2” fasteners. I like how the fasteners have more engagement than the stock fasteners, but you can reuse the stock fasteners if you like.
CAUTION: You are installing fasteners into plastic. Do not over tighten the fasteners and don not use Loctite on these fasteners!

3. Route the wires through the firewall.

4. Install the cowl and check for interferences.

5. Install the prop adapter, spinner and prop and you are all set! NOTE: It may be necessary to enlarge the prop and spinner holes since the Turnigy prop shaft is 8mm.

6. As with any change to your plane, before flying ensure that the center of gravity is correct!