Your cart is empty

P-51D motor mount for a Turnigy SK3548

Price: $15.99
  • Model: A100011
  • Units in Stock: 47
  • Manufactured by: Custom RC Parts

Add to Cart:
Click image to enlarge

The Custom RC Parts designed motor mount for the Parkzone P-51D Mustang.

This mount allows you to install a Turnigy SK3548 on your plane.

It is machined out of 6061-T6 billet Aluminum.

All fasteners are included.

6061-T6 Aluminum.

16mm X 25mm slots for 3mm fasteners.

14.0mm clearance hole.

Designed for motors with an operating length "F" of 55mm.

Turngy SK3548

Parkzone P-51D Mustang BL

The stock spinner works well with the stock prop and Master Airscrew props.

APC props will not fit without modifying the spinner and/or the prop. The mount does not affect the fit of the prop.

The Great Planes p/n GPMQ4773 allows you to use APC props.

1. Attach the motor to the motor mount using the 4, M3-.5 X 6 fasteners. Screw the fasteners in until they contact the motor mount then back them out a quarter turn. Ensure that the collar on the motor is centered in the clearance hole in the motor mount. Now tighten the fasteners. Once the motor is secured to the mount, spin the motor to make sure that there are no interferences. It’s a good idea to use a little Loctite on the threads.

2. Install the motor and mount on the plane using the #4 X 1/2” fasteners. I like how the fasteners have more engagement than the stock fasteners, but you can reuse the stock fasteners if you like.
CAUTION: You are installing fasteners into plastic. Do not over tighten the fasteners and don not use Loctite on these fasteners!

3. Route the wires through the firewall.

4. Install the cowl and check for interferences.

5. Install the prop adapter, spinner and prop and you are all set!

6. As with any change to your plane, before flying ensure that the center of gravity is correct!