Your cart is empty

F4U-1A Corsair motor mount for the stock 15BL

Price: $15.99
  • Model: A100018
  • Units in Stock: 11
  • Manufactured by: Custom RC Parts

Add to Cart:
Click image to enlarge

The Custom RC Parts designed motor mount for the ParkZone F4U-1A Corsair is a replacement for the stock mount.

The mount machined out of 6061-T6 billet Aluminum.

All fasteners included.

6061-T6 Aluminum.

19mm X 30mm slots for 3mm fasteners.

14.0mm clearance hole.

Designed for motors with an operating length "F" of 61mm.

Weight: 21g

Stock 15BL
E-flite Power 15

Parkzone Stinson Reliant SR-10
Parkzone T-28 Trojan
Parkzone F4U Corsair
Parkzone F4U-1A Corsair
Parkzone P-47D Thunderbolt

1. Install the motor mount using the 4, M3-.5 X 8 fasteners. Screw the fasteners in until they contact the motor mount then back them out a quarter turn. Ensure that the collar on the motor is centered in the clearance hole in the motor mount. Now tighten the fasteners. Once the motor is secured to the mount, spin the motor to make sure that there are no interferences.
CAUTION: You are installing fasteners into plastic. Do not over tighten the fasteners.

2. Install the motor and mount on the plane using the #4 X 1/2” fasteners. I like how the fasteners have more engagement than the stock fasteners, but you can reuse the stock fasteners if you like.
CAUTION: You are installing fasteners into plastic. Do not over tighten the fasteners.

3. Route the wires through the firewall.

4. Install the cowl and check for interferences.

5. Install the prop adapter and prop and you are all set!

6. As with any change to your plane, before flying ensure that the center of gravity is correct!