Your cart is empty

T-28 Trojan Motor Mount for a Turnigy G15

Price: $15.99
  • Model: A100106
  • Units in Stock: 39
  • Manufactured by: Custom RC Parts

Add to Cart:
Click image to enlarge

The Custom RC Parts designed motor mount for the Parkzone T-28 Trojan.  This mount allows you to install a Turnigy G15 on your plane.

It is machined out of 6061-T6 billet Aluminum. All fasteners are included.

6061-T6 Aluminum.

19mm X 30mm slots for 3mm fasteners.

14mm clearance hole.

Designed for motors with an operating length "F" of 68mm.

Weight: 15g

E-flite Power 2
Turnigy G15

Parkzone F4U Corsair
Parkzone T-28 Trojan
Parkzone Stinson Reliant SR-10

1. Install the motor on the motor mount using the 4, M3-.5 X 6 fasteners. Screw the fasteners in until they contact the motor mount then back them out a quarter turn. Ensure that the collar on the motor is centered in the clearance hole in the motor mount. Now tighten the fasteners. Once the motor is secured to the mount, spin the motor to make sure that there are no interferences. It’s a good idea to use a little Loctite on the threads.

2. Install the motor and mount on the plane using the #4 X 1/2” fasteners. I like how the fasteners have more engagement than the stock fasteners, but you can reuse the stock fasteners if you like.
CAUTION: You are installing fasteners into plastic. Do not over tighten the fasteners.

3. Route the wires through the firewall.

4. Install the cowl and check for interferences.

5. Install the prop adapter and prop and you are all set!

6. As with any change to your plane, before flying ensure that the center of gravity is correct!