Your cart is empty

F4F Wildcat motor mount for a Turnigy C3536

Price: $15.99
  • Model: A100037
  • Units in Stock: 12

Add to Cart:
Click image to enlarge

The Custom RC Parts designed motor mount for the ParkZone F4F Wildcat.

This mount allows you to install an E-flite 480, Turnigy 3536C-1100 or a Rimfire 3536-1200 on your plane.

It is machined out of 6061-T6 billet Aluminum.

All fasteners are included.

6061-T6 Aluminum.

16mm X 25mm slots for 3mm fasteners.

11.13mm clearance hole.

Designed for motors with an operating length "F" of 41mm.

Weight: 14g

E-flite 480
Turnigy 3536C-1100
Rimfire 3536-1200

F4F Wildcat

When using a Turnigy 3536C-1100 or a Rimfire 3536-1200 you have to open the prop shaft clearance hole up to 1.5"

1. Attach the motor to the motor mount using the 4, M3-.5 X 6 fasteners. Screw the fasteners in until they contact the motor mount then back them out a quarter turn. Ensure that the collar on the motor is centered in the clearance hole in the motor mount. Now tighten the fasteners. Once the motor is secured to the mount, spin the motor to make sure that there are no interferences. It’s a good idea to use a little Loctite on the threads.

2. Install the motor and mount on the plane using the #4 X 1/2” fasteners. I like how the fasteners have more engagement than the stock fasteners, but you can reuse the stock fasteners if you like.
CAUTION: You are installing fasteners into plastic. Do not over tighten the fasteners and don not use Loctite on these fasteners!

3. Route the wires through the firewall.

4. You need to open up the prop shaft clearance hole in the cowl to 1.5”.

5. Install the cowl and check for interferences.

6. Install the prop adapter and prop and you are all set!

7. As with any change to your plane, before flying ensure that the center of gravity is correct!